Re: n2100 crash...

[Przemyslaw Kwiatkowski <micha@micha.waw.pl>]

Lennert Buytenhek pisze:

>>>> md: data-check of RAID array md0
>>>> md: minimum _guaranteed_  speed: 1000 KB/sec/disk.
>>>> md: using maximum available idle IO bandwidth (but not more than 200000
>>>> KB/sec) for data-check.
>>>> md: using 128k window, over a total of 14651136 blocks.
>>>> md: delaying data-check of md1 until md0 has finished (they share one or
>>>> more physical units)
>>>> md: md0: data-check done.
>>>> md: data-check of RAID array md1
>>>> md: minimum _guaranteed_  speed: 1000 KB/sec/disk.
>>>> md: using maximum available idle IO bandwidth (but not more than 200000
>>>> KB/sec) for data-check.
>>>> md: using 128k window, over a total of 961128704 blocks.
>>>> RAID1 conf printout:
>>>>  --- wd:2 rd:2
>>>>  disk 0, wo:0, o:1, dev:sda1
>>>>  disk 1, wo:0, o:1, dev:sdb1
>>>> md: md1: data-check done.
>>>> RAID1 conf printout:
>>>>  --- wd:2 rd:2
>>>>  disk 0, wo:0, o:1, dev:sda3
>>>>  disk 1, wo:0, o:1, dev:sdb3
>>>> drivers/usb/class/usblp.c: usblp0: removed
>>>>
>>>> Any ideas?
>>> These seem normal messages.  What else is going on when the box
>>> hangs?
>> Nothing. The box simply stops to respond, power button does not work and
>> only solution is to disconnect power supply. It happens irregular -
>> sometimes twice a day, sometimes not within a week.
> 
> Do you have a serial console on it?


Yes. It shows only the raid and usblp messages, which you can see above.
After hang up the console does not work.

-- 
MiCHA