Re: n2100 crash...

[Lennert Buytenhek <buytenh@wantstofly.org>]

On Tue, Mar 04, 2008 at 09:00:34PM +0100, Przemyslaw Kwiatkowski wrote:

> md: data-check of RAID array md0
> md: minimum _guaranteed_  speed: 1000 KB/sec/disk.
> md: using maximum available idle IO bandwidth (but not more than 200000
> KB/sec) for data-check.
> md: using 128k window, over a total of 14651136 blocks.
> md: delaying data-check of md1 until md0 has finished (they share one or
> more physical units)
> md: md0: data-check done.
> md: data-check of RAID array md1
> md: minimum _guaranteed_  speed: 1000 KB/sec/disk.
> md: using maximum available idle IO bandwidth (but not more than 200000
> KB/sec) for data-check.
> md: using 128k window, over a total of 961128704 blocks.
> RAID1 conf printout:
>  --- wd:2 rd:2
>  disk 0, wo:0, o:1, dev:sda1
>  disk 1, wo:0, o:1, dev:sdb1
> md: md1: data-check done.
> RAID1 conf printout:
>  --- wd:2 rd:2
>  disk 0, wo:0, o:1, dev:sda3
>  disk 1, wo:0, o:1, dev:sdb3
> drivers/usb/class/usblp.c: usblp0: removed
> 
> Any ideas?

These seem normal messages.  What else is going on when the box
hangs?