Check (lsmod)
that you have usb_storage loaded. -- br Sven Daniel van Eeden wrote: Try this command and post it to the list. $ cat /proc/bus/usb/devices | grep ^T: Daniel van Eeden <daniel_e@dds.nl> Op ma, 20-12-2004 te 14:20 +0100, schreef Lorenzo Milesi:Hi I'm having some problems with USB2. According to ASUS specs, my pc (A2526KUH) has 5xUSB2 ports. But lspci says the following: 0000:00:02.0 USB Controller: nVidia Corporation nForce3 USB 1.1 (rev a5) 0000:00:02.1 USB Controller: nVidia Corporation nForce3 USB 1.1 (rev a5) 0000:00:02.2 USB Controller: nVidia Corporation nForce3 USB 2.0 (rev a2) Anyway when I insert my Packard Bell 1Gb mp3 player it's used by the OHCI driver, instead of the (also loaded) ehci! I tried all the five ports, all the same! I tried also an external USB2 HDD but does the same. This is the output of messages Dec 20 14:13:58 localhost kernel: ohci_hcd 0000:00:02.1: wakeup Dec 20 14:13:58 localhost kernel: usb 2-2: new full speed USB device using address 2 Dec 20 14:14:01 localhost kernel: scsi1 : SCSI emulation for USB Mass Storage devices Dec 20 14:14:01 localhost kernel: Vendor: Packard Model: Portable Player Rev: 0100 Dec 20 14:14:01 localhost kernel: Type: Direct-Access ANSI SCSI revision: 02 Dec 20 14:14:01 localhost kernel: SCSI device sda: 2041344 512-byte hdwr sectors (1045 MB) Dec 20 14:14:01 localhost usb.agent[8228]: usb-storage: already loaded Dec 20 14:14:01 localhost kernel: sda: Write Protect is off Dec 20 14:14:02 localhost kernel: /dev/scsi/host1/bus0/target0/lun0:<7>usb-storage: queuecommand called Dec 20 14:14:02 localhost kernel: p1 Dec 20 14:14:02 localhost kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 Dec 20 14:14:02 localhost scsi.agent[8243]: disk at /devices/pci0000:00/0000:00:02.1/usb2/2-2/2-2:1.0/host1/1:0:0:0 After these message I tried copying 139Mb: it took 2m30 -> 1Mb/s (fullspeed) any ideas? thanks maxxer |