USB2
Hi
I'm having some problems with USB2.
According to ASUS specs, my pc (A2526KUH) has 5xUSB2 ports.
But lspci says the following:
0000:00:02.0 USB Controller: nVidia Corporation nForce3 USB 1.1 (rev a5)
0000:00:02.1 USB Controller: nVidia Corporation nForce3 USB 1.1 (rev a5)
0000:00:02.2 USB Controller: nVidia Corporation nForce3 USB 2.0 (rev a2)
Anyway when I insert my Packard Bell 1Gb mp3 player it's used by the
OHCI driver, instead of the (also loaded) ehci! I tried all the five
ports, all the same!
I tried also an external USB2 HDD but does the same.
This is the output of messages
Dec 20 14:13:58 localhost kernel: ohci_hcd 0000:00:02.1: wakeup
Dec 20 14:13:58 localhost kernel: usb 2-2: new full speed USB device
using address 2
Dec 20 14:14:01 localhost kernel: scsi1 : SCSI emulation for USB Mass
Storage devices
Dec 20 14:14:01 localhost kernel: Vendor: Packard Model: Portable
Player Rev: 0100
Dec 20 14:14:01 localhost kernel: Type: Direct-Access
ANSI SCSI revision: 02
Dec 20 14:14:01 localhost kernel: SCSI device sda: 2041344 512-byte
hdwr sectors (1045 MB)
Dec 20 14:14:01 localhost usb.agent[8228]: usb-storage: already loaded
Dec 20 14:14:01 localhost kernel: sda: Write Protect is off
Dec 20 14:14:02 localhost kernel:
/dev/scsi/host1/bus0/target0/lun0:<7>usb-storage: queuecommand called
Dec 20 14:14:02 localhost kernel: p1
Dec 20 14:14:02 localhost kernel: Attached scsi removable disk sda at
scsi1, channel 0, id 0, lun 0
Dec 20 14:14:02 localhost scsi.agent[8243]: disk at
/devices/pci0000:00/0000:00:02.1/usb2/2-2/2-2:1.0/host1/1:0:0:0
After these message I tried copying 139Mb: it took 2m30 -> 1Mb/s (fullspeed)
any ideas?
thanks
maxxer
Reply to:
- Follow-Ups:
- Re: USB2
- From: Daniel van Eeden <daniel_e@dds.nl>