Re: problems with 2.4.2x on alpha.
Maciej Matysiak wrote:
thank you, i'll try that. could you please describe your storage setup?
i mean, what's connected to your scsi card (internal/external drives).
if i remember correctly, the problem which i have appears only when nothing
is connected to external scsi interface (i have only internal drives: two
disks and cd-rom). but i could be wrong, i can't find the message with
detailed description :( it was posted here not too long ago.
Here's what kernel reports:
ERROR: SCSI host `isp1020' has no error handling
ERROR: This is not a safe way to run your SCSI host
ERROR: The error handling must be added to this driver
<... some trace info ...>
qlogicisp : new isp1020 revision ID (5)
scsi0 : QLogic ISP1020 SCSI on PCI bus 01 device 40 irq 36 I/O base 0x8000
Vendor: IBM Model: IC35L018UWD210-0 Rev: S5BS
Type: Direct-Access ANSI SCSI revision: 03
Vendor: QUANTUM Model: ATLAS10K2-TY184L Rev: DA40
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sda: 35843670 512-byte hdwr sectors (18352 MB)
SCSI device sda: drive cache: write back
sda: sda1 sda2 sda3 sda4 sda5 sda6
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
sdb: Spinning up disk....................ready
SCSI device sdb: 35860910 512-byte hdwr sectors (18361 MB)
SCSI device sdb: drive cache: write back
sdb: sdb1
Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0
Attached scsi generic sg1 at scsi0, channel 0, id 1, lun 0, type 0
I have the cd-rom on IDE. Dunno about the warnings; so far, so good.
This is the kernel image I use:
http://testoapina.tky.hut.fi/~jaska/kernel-image-2.6.5_1_alpha.deb .
Jaska
Reply to: