ide-pci bug?: too many ide interfaces no room in table
i've tried a silicon image and a promise card. both are ata 133. i've tried
2.4.21 and .22-rc2. both drivers cause this msg, from ide-pci.c. my
up2000+'s onboard works fine.
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
CY82C693: IDE controller at PCI slot 00:05.1
CY82C693: chipset revision 0
CY82C693: not 100% native mode: will probe irqs later
CY82C693U driver v0.34 99-13-12 Andreas S. Krebs (akrebs@altavista.net)
ide0: BM-DMA at 0x8c40-0x8c47, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0x8c48-0x8c4f, BIOS settings: hdc:pio, hdd:pio
PDC20269: IDE controller at PCI slot 01:09.0
PDC20269: chipset revision 2
PDC20269: not 100% native mode: will probe irqs later
PDC20269: ROM enabled at 0x209024000
PDC20269: too many IDE interfaces, no room in table
PDC20269: too many IDE interfaces, no room in table
PDC20269: neither IDE port enabled (BIOS)
hda: OPTORITECD-RW CW5202, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: attached ide-cdrom driver.
hda: ATAPI 52X CD-ROM CD-R/RW drive, 8192kB Cache
Uniform CD-ROM driver Revision: 3.12
--
Tom Vier <tmv@comcast.net>
DSA Key ID 0xE6CB97DA
Reply to: