Re: AlphaStation 500 MILO problems + Voodoo questions
Jay Estabrook <Jay.Estabrook@compaq.com> writes:
> Finally, I had the following success running X from the XLT MILO:
>
> 3. ATI Radeon 7500
Did you try that one with the digital output? I briefly tried the
digital output on an AGP Radeon 7500 in an UP1500, but X 4.2.1 said:
(II) RADEON(0): No legacy BIOS found -- trying PCI
(EE) RADEON(0): Cannot read V_BIOS (5)
(WW) RADEON(0): Restoring MEM_CNTL (00000000), setting to 2e002e01
(WW) RADEON(0): Restoring CONFIG_MEMSIZE (08000000), setting to 08000000
(--) RADEON(0): Chipset: "ATI Radeon 7500 QW (AGP)" (ChipID = 0x5157)
(--) RADEON(0): Linear framebuffer at 0xe0000000
(--) RADEON(0): MMIO registers at 0xd8000000
(--) RADEON(0): BIOS at 0xf0000000
(--) RADEON(0): VideoRAM: 131072 kByte (64-bit DDR SDRAM)
(WW) RADEON(0): Video BIOS not detected in PCI space!
(WW) RADEON(0): Attempting to read Video BIOS from legacy ISA space!
(WW) RADEON(0): Video BIOS not found!
(II) RADEON(0): initializing int10
(II) RADEON(0): No legacy BIOS found -- trying PCI
(EE) RADEON(0): Cannot read V_BIOS (5)
(WW) RADEON(0): Video BIOS not detected, using default PLL parameters!
(II) RADEON(0): PLL parameters: rf=2700 rd=67 min=12500 max=35000; xclk=16615
(==) RADEON(0): Using gamma correction (1.0, 1.0, 1.0)
(WW) RADEON(0): Mode 1280x1024 is out of range.
Valid mode should be between 640x480-0x0
(WW) RADEON(0): Mode 640x480 is out of range.
Valid mode should be between 640x480-0x0
(EE) RADEON(0): No valid mode found for this DFP/LCD
Analog works fine if I add Option "CrtScreen"...
--
Falk
Reply to: