Qlogic 1040B

[Jan Lentfer <Jan.Lentfer@web.de>]

Hi all,

I bougth a Qlogic 1040B SCSI controller to replace the Adaptec
controller in my PWS 500a, thus actualling switching it to an 500au.

The problem I have is:
The controller is found by SRM (show dev) (hooray!!!)
I build the "qlogicisp" kernel module and the controller is reported as:
scsi0 : QLogic ISP1020 SCSI on PCI bus 01 device 50 irq 44 I/O base
0x8800

But my harddisks are not found. When I attach them back to the Adaptec,
this is what I get:
scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.8
        <Adaptec 2940 Ultra SCSI adapter>
        aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs

blk: queue fffffc00001f3cb0, no I/O memory limit
  Vendor: COMPAQ    Model: ST15150W          Rev: 6216
  Type:   Direct-Access                      ANSI SCSI revision: 02
blk: queue fffffc001b7a00d0, no I/O memory limit
  Vendor: SEAGATE   Model: ST19171W          Rev: 0023
  Type:   Direct-Access                      ANSI SCSI revision: 02
blk: queue fffffc001b7a02d0, no I/O memory limit
scsi1:A:0:0: Tagged Queuing enabled.  Depth 253
scsi1:A:8:0: Tagged Queuing enabled.  Depth 253
Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
Attached scsi disk sdb at scsi1, channel 0, id 8, lun 0
(scsi1:A:0): 10.000MB/s transfers (10.000MHz, offset 8)
sda: Spinning up disk...............ready
SCSI device sda: 8386000 512-byte hdwr sectors (4294 MB)
 sda: sda1 sda2
(scsi1:A:8): 40.000MB/s transfers (20.000MHz, offset 8, 16bit)
SCSI device sdb: 17783112 512-byte hdwr sectors (9105 MB)
 sdb: sdb1 sdb2

Any suggestions???? Why are my harddisks not found by the QLogic
adapter?


TIA,

Jan
-- 
Jan Lentfer
System Administrator
Molekulare Zellbiologie / AG Holstein, TU Darmstadt, Schnittspahnstr.
10, 64287 Darmstadt