From: Rob Bogus <rob23@tmr.com>
I have some (admitedly old) CD readers with micro-jumpers about 2mm wide
to set the LUN, and I've used SCSI drives with pads to solder a jumper,
so I would not be surprised to find that some SCSI burners still have
LUN jumpers. I have to take apart a pait of systems with SCSI burners in
the next few days, a Phillips 2600 and a Sony(?) in the other. I'll
look, now that you have me curious.
bubba:davidsen> cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 02 Lun: 00
Vendor: MATSHITA Model: CD-R CW-7502 Rev: 4.17
Type: CD-ROM ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 05 Lun: 00
Vendor: ARCHIVE Model: Python 25501-XXX Rev: 2.73
Type: Sequential-Access ANSI SCSI revision: 01
Host: scsi1 Channel: 00 Id: 00 Lun: 00
Vendor: PLEXTOR Model: CD-R PX-W8432T Rev: 1.05
Type: CD-ROM ANSI SCSI revision: 02
So there are Plextor and Matshita drives in that one, as well as a 4mm
DAT and some 8mm tapes which are unplugged. I'll look for LUN jumpers
when I rebuild two systems into a single functional system.
In any case, my question is if the software would support such.
Ha, I can ssh into the system which is still up, and it tells me:
Looks like you confuse the Target ID with the lun.