how to create again eth0
Hi,
on my machine (Desktop PC) I have 2 network card : wireless (rt61 802.11) and a wired card (BCM44). When I install debian 5.
The wired card is detected and logical name eth0 is assigned, while wireless is not assigned I install firmeware* software to configure the card. It is done in some way ( I used mnetwork from mepis, it works fine).
Now the problem: eth0 disapears, and no eth0 inteface found ?? ifconfig gives just wlan0.
Question1:
why there is no eth0, it was before configuration of wlan0 ?
How to active again eth0, or ho to create the logical eth0?
thanks a lot
best regards
bela
Reply to: