Re: Kernel panic installing Etch
2008/3/3, Juan Seet <email@example.com>:
> 2008/3/3, Douglas A. Tutty <firstname.lastname@example.org>:
> > On Mon, Mar 03, 2008 at 07:50:15PM -0300, Juan Seet wrote:
> > > Hello, I downloaded netinst for AMD64, I tried to install it and I get
> > > the following message:
> > > Code: 89 d5 81 e5 ff 00 00 00 75 70 48 c1 ea 08 48 8d b3 18 10 00
> > > console shuts up ...
> > > <0>Kernel panic - not syncing: Aiee, killing interrupt handler!
> > >
> > > System data:
> > > Processor: DualCore AMD Athlon 64 X2, 2100 MHz (10.5 x 200) 4000+
> > > Motherboard: ECS AMD690GM-M2
> > > Chipset: AMD 690G, AMD Hammer
> > > Memory: 2048 MB (DDR2-667 DDR2 SDRAM)
> > > Video card: ATI Radeon X1650 Series (512 MB)
> > >
> > > Any idea? Thanks for your time.
> > You don't say if this is Sarge, Etch, Lenny, or Sid. Its important.
> > Equally important, you should read the installation manual where it says
> > what to do if you have a problem: the same as if you don't: send in an
> > installation report. Since you have a problem, subscribe to debian-boot
> > first where your email well get posted by the installation reports
> > system. The people who lurk on that list are the people who write the
> > installer and ensure that it boots. They will either know right away
> > what to do, or will tell you what magical incantation to give the kernel
> > so that it says something that will help them help you.
> > Good luck.
> > Doug.
> 0k thanks, I'll suscribe to debian-boot, but this mail subject is
> "Kernel panic installing Etch" ;)
I can't find the debian-boot list, maybe you meant