Re: printable area setup with CUPS - HPIJS
> On Sun, Apr 30, 2006 at 11:23:09AM -0400, Roberto C. Sanchez wrote:
> > I'm not sure what you are asking. Are you printing on Letter or A4 in
> > the firstplace?
> I'm printing on A4 in the first place.
The properties of the Imageable Area of my printer are:
Page Size: 8.0 x 11.06 in or 203.2 x 281.0 mm
Lower-Left: 0.14 x 0.51 in or 3.4 x 12.8 mm
Upper-Right: 8.14 x 11.57 in or 206.6 x 293.8 mm
With these values I can print a document on paper size of A4 with margin
lines shown hereinafter
> |-----------0.5 cm-------------|
> ||----------1.0 cm------------||
> |||---------1.5 cm-----------|||
> ||| |||
> ||| |||
> ||| |||
> ... ...
> ||| |||
> ||| |||
> ||| |||
> |||---------1.5 cm-----------|||
> The margin line at 1.0 cm is not showed up.
> The margin line at 0.5 cm is not showed up.
but the margin lines at the bottom of the page are not shown up.
I would like to setup CUPS and/or HPIJS so that I get the imageable area
increased and then I expect to can print my document so I can see the
margin lines at the bottom of the A4 page, like:
> |-----------0.5 cm-------------|
> ||----------1.0 cm------------||
> |||---------1.5 cm-----------|||
> ||| |||
> ||| |||
> ||| |||
> ... ...
> ||| |||
> ||| |||
> ||| |||
> |||---------1.5 cm-----------|||
> ||----------1.0 cm------------||
> |-----------0.5 cm-------------|
I try to see any settings in the file
/etc/cups/ppd/Business_Inkjet_1000.ppd
and find lines:
*DefaultImageableArea: A4
*ImageableArea Letter/Letter: "18 36 594 783"
*ImageableArea A4/A4: "9.72 36 585.28 833"
...
I don't know with which values can I change these settings?
Can I setup the CUPS and/or HPIJS to get the imageable area increased?
Any advices is appreciated!
--
Regards, Csányi Paul
http://www.ektf.hu/~Csanyi.Pal (Up to now, it is in Hungarian only.)
http://csanyipal.info/moodle <<<--- Moodle - Course Management System
http://csanyipal.info:81 <<<--- sTeam - Cooperative Learning
Reply to: