Re: possible solution for eth0 eth1 mixup on boot
Apparently, _Chris Bannister_, on 23/06/05 12:30,typed:
> Try setting Plug-n-Play to NO/OFF/FALSE in bios
There are around 3 method to do so (learned while googling for the
problem, maybe somewhere metioned them on this list too, not sure). I
chose an easier one. I just mention the modules of the two NICs in
/etc/modules in the order I want the cards to be numbered. So module for
eth0 goes first and for eth1 goes next. The only problem is that this
method will not work if a NIC card is replaced with another one which
may need a different module.
Please remove the underscores ( the '_' symbols) from my email address
to obtain the correct one. Apologies, but the fudging is to remove spam.