Debian+Tekram 390u2w cannot run full 40MB/s speed?
I have a Tekram Ultra 2 SCSI card (DC390u2b eq
DC390u2w) with an IBM Ultra 2 SCSI(LVD) Hard disk
installed on the Debian 2.2.
After successfully installed the Debian, I found a
Debian cannot run the SCSI(LVD) to 40MB full speed.
(This system was installed Mandrake before and the
SCSI Card was able to ran at 40Mb/s full speed by
Now, Debian is running it with the sym53c8xx on 10MB/s
In Mandrake I don't need to install driver manually,
it use ncr53cxx on 40MB/s automaticlly.
Is there anyway I could fix this problem(such as
modify a file) without install a offical Terkram SCSI
Here is the dmesg:
scsi: <fdomain> Detection failed (no card)
NCR53c486a: no avaliable ports found
sym53c416.c: Version 1.0.0
sym53c8xx: at PCI bus 0, device 12, function 0
sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up)
sym53c8xx: 53c895 detected
sym53c895-0: rev=0x01, base=0xe1000000,
sym53c895-0: ID7, Fast-40, Parity Checking
sym53c895-0: on-chip RAM at 0xe000000
sym53c895-0: restart (scsi reset).
sym53c895-0: Downloading SCSI SCRIPTS.
sym53c8xx: at PCI bus 0, device 12, function 0,
sym53c8xx: IO region 0xb000 to 0xb07f is in use
Failed initialization of WD-7000 SCSI card!
IBM MCA SCSI: No Microchannel-bus support present ->
megaraid: v107 (December 22, 1999)
3w-xxxx: tw_fincards(): No cards found.
scsi0 : sym53c8xx -version 1.3g
scsi : 1 host.
Vendor: IBM Model: DENS-309170W Rev: SAH0
Tuye: Direct-Access ANSI SCSI revision: 03
Detected scsi disk sda at scsi0, channel 0, id6, lun0
sym53c895-0<6.*>: FAST-5 WIDE SCSI 10.0MB/s (200 ns,
p.s. This is the first time I use mailing list, if I
posted to the incorrect mailling list, please forgive
me and tell me where should I post to . Thank you.
Do You Yahoo!?
Yahoo! Shopping - Thousands of Stores. Millions of Products.