lp problems, with iomega ZIp pass through on parallel port
I have an Iomega zip on the parallel port, and unless I power it off at
boot time, I cannot seem to see the printer that is chained through it. O
recall that there was a module for this, can someone give a pointer?
Thanks,
Greg Guthrie
--------------------------------------------------------
Dr. Gregory Guthrie
guthrie@mum.edu (515)472-1125 Fax: -1103
Computer Science Department
College of Science and Technology
Maharishi University of Management
(Maharishi International University 1971-1995)
http://www.mum.edu/cs_dept
--------------------------------------------------------
Reply to: