Problema con mi wireless
He conseguido instalar el driver de Madwifi en mi Debian Sid y con lsmod
salen cargados los modulos.
1) Esta es la salida de iwconfig :
----------------
linux:/home/mcorbella# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
ath0 IEEE 802.11 ESSID:""
Mode:Managed Frequency:2.412GHz Access Point: 00:00:00:00:00:00
Bit Rate:0kb/s Tx-Power:50 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/94 Signal level=-95 dBm Noise level=-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
sit0 no wireless extensions.
----------------
2) Esta es la salida de ifconfig :
linux:/home/mcorbella# ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:FC:C1:9B:AA
inet addr:192.168.0.43 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::250:fcff:fec1:9baa/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:719 errors:0 dropped:0 overruns:0 frame:0
TX packets:659 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:691002 (674.8 KiB) TX bytes:74694 (72.9 KiB)
Interrupt:11 Base address:0x8f00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:16796 errors:0 dropped:0 overruns:0 frame:0
TX packets:16796 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1852534 (1.7 MiB) TX bytes:1852534 (1.7 MiB)
----------------
Este es mi interfaces (la parte wireless esta comentada, luego explico
el por que) :
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# This entry denotes the loopback (127.0.0.1) interface.
auto lo
iface lo inet loopback
# This entry was created during the Debian installation
auto eth0
iface eth0 inet dhcp
name Tarjeta de red Ethernet
# auto ath0
# iface ath0 inet dhcp
# wireless_mode managed
# wireless_essid public
# wireless_rate 54M auto
# wireless_enc off
# name Tarjeta de red inalambrica
Bueno si no comento la parte de ath0 el ordenador se me bloquea al
arrancar diciendome :
/etc/dhclient-script : line 120 : 1327 segmentation fault ifconfig
$interfaces up
No se como hacer rular la tarjeta. Alguien puede echarme una mano ???
Reply to: