installation sur dfi ps83-bl
Bonjour,
J'ai l'intention d'acheter un carte m?ère DFI PS83-BL et j'aimerais
savoir si qqun a d?éj?à install?é une woody (ou sarge) sur une telle
carte. A toutes fins utiles je vous communique ses sp?écifications :
======================================================================
* CPU Socket*
- Socket 478
======================================================================
* Chipset*
- Intel 865PE chipset
- Intel 865PE Memory Controller Hub (MCH)
- Intel 82801EB I/O Controller Hub (ICH5)
======================================================================
* Memory*
- Supports dual channel (128-bit wide) memory interface
- Each channel supports 2 DIMM sockets
- Supports up to 4GB system memory
- Synchronous operation with processor system bus
- PC2100/PC2700/PC3200 (DDR266/DDR333/DDR400) with 800MHz FSB
CPU. DDR333 will run at 320MHz memory frequency when used with
800MHz FSB CPU.
- PC2100/PC2700 (DDR266/DDR333) with 533MHz FSB CPU
- PC2100 (DDR266) with 400MHz FSB CPU
- Supports non-ECC (x64) DIMM using 128Mb, 256Mb or 512Mb
- Supports unbuffered DIMMs
======================================================================
* BIOS *
- Award BIOS, Windows 98SE/2000/ME/XP Plug and Play compatible
- CPU/DRAM overclocking
- AGP/PCI/SATA overclocking
- CPU/DIMM overvoltage
- Supports SCSI sequential boot-up
- Flash EPROM for easy BIOS upgrades
- Supports DMI 2.0 function
- 2Mbit flash memory
======================================================================
* Audio*
- 20-bit stereo full-duplex codec with independent variable sampling rate
- High quality differential CD input
- True stereo line level outputs
- S/PDIF-in/out interface
- 6-channel audio output
======================================================================
* LAN*
- Uses Realtek RTL8101L fast ethernet controller
- Integrated IEEE 802.3, 10BASE-T and 100BASE-TX compatible PHY
======================================================================
* IDE*
- Supports ATA/33, ATA/66 and ATA/100 hard drives
- PIO Mode 4 Enhanced IDE (data transfer rate up to 14MB/sec.)
======================================================================
* Serial ATA*
- Supports two SATA (Serial ATA) interfaces which are compliant with
SATA 1.0 specification (1.5Gbps interface)
======================================================================
* AGP*
- Supports 1.5V AGP 8x (2.13GB/sec.) and AGP 4x (1066MB/sec.) for 3D
graphics applications (AGP 2x and 3.3V AGP card are not supported)
- Supports AGP 3.0 and AGP 2.0 spec.
======================================================================
voil?à
merci d'avance
--
Philippe Monroux
Ile de la Reunion
E 55.3 S 21.5
Reply to: