Re: XF4 on Mach64 and 2.2 kernel?
Adam C Powell IV wrote:
> I'll look into the signal 11 in xf86cfg.
I wouldn't bother about it.
If you want to try the ati driver, copying the fbdev Device Section and adding
Option "UseFBDev" may work. Good luck :)
> And it fails with 2.2.18pre21 for two reasons: the fb doesn't give it a
> default mode (so I need to set it),
Note that the 3.3 way of using a mode "default" doesn't work anymore. You need
to use an empty Modes line (or none at all) for the fbdev driver to use the
default mode.
> and I haven't figured out how to cenfigure it for the new input layer stuff
> (gpm fails too).
Have you looked at http://ppclinux.apple.com/~benh/ and followed the link to
Franz Sirl's page on the new input layer?
> And the ati driver locks hard with 2.2.15, but I was warned. (Can't use
> 2.4 full-time until the ipmasq package supports it.)
It doesn't? Why not?
Michel
--
Earthling Michel Dänzer (MrCooper) \ CS student and free software enthusiast
Debian GNU/Linux (powerpc,i386) user \ member of XFree86 and The DRI Project
Reply to: