Bug#347186: linux-image-2.6.14-2-alpha-generic: garbled Matrox framebuffer
On Wed, Jan 11, 2006 at 07:24:04PM +0800, Antonino A. Daplas wrote:
> maximilian attems wrote:
> > dear adaplas,
> >
> > could you please take a look at this matroxfb debian bug report:
> > http://bugs.debian.org/347186
> >
> > On Mon, 09 Jan 2006, Steve Langasek wrote:
> >
> > <snipp>
> >>>> Sigh, can't get a break with alpha kernel support around here. After
> >>>> upgrading to 2.6.14 (from 2.4.27), the Matrox framebuffer no longer works
> >>>> correctly on my alpha with a Matrox Millenium II. The matroxfb_base module
> >>>> loads without error, but gives me corrupt video output only.
> >>> Try turning off acceleration.
> >> Doesn't make a difference.
> >>
> >> What did make a difference was, after googling, loading fbcon manually
> >> before loading matroxfb_base. Given that I'm loading matroxfb_base by hand
> >> (/etc/modules), it's not getting loaded via udev or anything like that, it
> >> seems to me that it's my responsibility to load fbcon by hand as well, but
> >> it's still something of an unexpected change from 2.4.
>
> You can always compile fbcon statically and the fbdev as modules so you get
> the same behavior as 2.4. (The separation of fbdev from fbcon is advantageous
> in embedded systems where the console is not needed).
>
> (There's a new document Documentation/fb/fbcon.txt that explains some of the
> changes. It's new in 2.6.15).
Also, note :
http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=311815
[powerpc] screen garbage when using matroxfb acceleration
this is on powerpc64 though, so it may be some 64-bitness issue.
Friendly,
Sven Luther
Reply to: