Re: had to install from a sarge netinst CD and then upgrade to etch;
Op 18-11-2007 om 15:56 schreef Simon Vallet:
> Package: installation-reports
>
> * Boot method: Etch i386 netinst CD
> * Image version:
> http://cdimage.debian.org/debian-cd/4.0_r1/i386/iso-cd/debian-40r1-i386-netinst.iso
> * Date: 17/11/2007
>
<snip/>
>
> * Base System Installation Checklist:
> [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
> Initial boot: [O]
> Detect network card: [E]
> Configure network: [ ]
> Detect CD: [O]
> Load installer modules: [O]
> Detect hard drives: [E]
> Partition hard drives: [ ]
> Install base system: [ ]
> Clock/timezone setup: [ ]
> User/password setup: [ ]
> Install tasks: [ ]
> Install boot loader: [ ]
> Overall install: [ ]
>
> * Comments/Problems:
>
> The CD image doesn't contain necessary drivers for a successful network install :
> - aacraid for the PERC 3/Di RAID controller
> - e1000 for the Intel 82544EI GE Controller
>
> I had to install from a sarge netinst CD and then upgrade to etch;
/me wonders if it is another CD build that wents wrong.
Reply to: