Bug#384342: installation-report: Illegal Instruction (sparc)
I just tried to install Debian (official etch netinstall image):
---------------------- schnipp --------------------------------
Sun Ultra 2 UPA/SBus (UltraSPARC-II 400MHz), No Keyboard
OpenBoot 3.19, 1024 MB memory installed, Serial #xxxxxxxx.
Ethernet address x:x:xx:xx:xx:xx, Host ID: xxxxxxxx.
Rebooting with command: boot cdrom
Boot device: /sbus/SUNW,fas@e,8800000/sd@6,0:f File and args:
SILO Version 1.4.13
\
Welcome to Debian GNU/Linux etch!
This is a Debian installation CDROM, built on 20070407-11:37.
Keep it once you have installed your system, as you can boot from it
to repair the system on your hard disk if that ever becomes necessary.
WARNING: You should completely back up all of your hard disks before
proceeding. The installation procedure can completely and irreversibly
erase them! If you haven't made backups yet, remove the rescue CD from
the drive and press L1-A to get back to the OpenBoot prompt.
Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent permitted
by applicable law.
[ ENTER - Boot install ] [ Type "expert" - Boot into expert mode ]
[ Type "rescue" - Boot into rescue mode ]
boot:
Allocated 8 Megs of memory at 0x40000000 for kernel
Loaded kernel version 2.6.18
Loading initial ramdisk (3879265 bytes at 0x3F802000 phys, 0x40C00000 virt)...
Illegal Instruction
ok ctrace
PC: 404434
Last leaf: jmpl f005f23c from 40004310
0 w %o0-%o5: (0 0 0 0 f005f23c 0 )
ok
--------------------- schnipp --------------------------------
It's not the original CD drive, cause that one was physically broken.
Is it possible, that the CD drive causes some of the error? I'll try
out a net boot next time...
Tschoeeee
Roland
Reply to: