Bug#395163: Installation report
Boot method: Floppy, dated 20061024
Image version: http://people.debian.org/~joeyh/d-i/images/daily/floppy/
Machine: HP Vectra VL 233MHz 64MB 2,6G IDE disk
Filesystem Type 1K-blocks Used Available Use% Mounted on
/dev/hda1 ext3 2324384 381848 1824460 18% /
udev tmpfs 10240 52 10188 1% /dev
devshm tmpfs 31104 0 31104 0% /dev/shm
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O ]
Detect network card: [O ]
Configure network: [O ]
Detect CD: [ ]
Load installer modules: [O ]
Detect hard drives: [O ]
Partition hard drives: [O ]
Install base system: [O ]
Clock/timezone setup: [O ]
User/password setup: [O ]
Install tasks: [O ]
Install boot loader: [O ]
Overall install: [O ]
Install was low memory mode, but this machine has 64MB memory.
Is installation from floppy always "low memory mode"?
Installation did not ask anything about which modules to load etc.,
which I think it should ask if it really is low memory mode install.
I deselected "standard system" from tasksel display, thinking I
can install that later, but it is not available when I start tasksel
in the installed system. So now some of the standard packages
are not installed.
Console keymap was not set up, the åäö keys did not work from console.
I'm not sure if this is the fault of the installer:
aptitude et al complain about GPG error and untrusted sources.
Are the keyrings in /etc/apt wrong or is the mirror I use,
ftp.fi.debian.org somehow wrong just now?
I can provide log files on request.
Please make sure that the hardware-summary log file, and any other
installation logs that you think would be useful are attached to this
Once you have filled out this report, mail it to firstname.lastname@example.org.