Bug#352654: installation-reports

[Poueck <poueck@poueck.com>]

Package: installation-reports

Boot method: USB CDROM (boot: linux vga=771)
Image version: http://cdimage.debian.org/cdimage/daily-builds/daily/ 
arch-latest/i386/iso-cd/debian-testing-i386-netinst.iso
Date: 2006-02-13 9:45 CET

Machine: VIA Epia M Mini ITX motheboard
Processor: VIA C3 (Samuel 2 600MHz)
Memory: 1GB
Partitions:
Could'nt get partition table under BusyBox, but I use lvm
logical partition 2.7G swap
logical partition 256M /boot ext3
LVM partition (rest of disk)
LV root 290M / ext3
LV tmp 411M /tmp ext3
LV usr 5.5G /usr ext3
LV var 3.5G /var ext3

Output of lspci and lspci -n:
Can't do that under BusyBox

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot worked:    [O ]

Configure network HW:   [O ]

Config network:         [ O]

Detect CD:              [ O]

Load installer modules: [O ]

Detect hard drives:     [ O]

Partition hard drives:  [ O]

Create file systems:    [ O]

Mount partitions:       [ O]

Install base system:    [ O]

Install boot loader:    [ O]

Reboot:                 [ E]

udev-event [xxx] : run_program: exec of program '/lib/udev/vol_id'  
failed
udev-event [xxx] : run_program: exec of program '/lib/udev/ 
udev_run_hotplugd' failed
udev-event [xxx] : run_program: exec of program '/lib/udev/ 
udev_run_devd' failed
(those 3 lines are repeated a lot of times)

ALERT! does not exist. Dropping to a shell!

BusyBox v1.01
[...]
/bin/sh: can't acces tty; job control turned off

Comments/Problems:

I strongly suppose that's an hardware problem. When I installed  
Sarge, lots of messages about hotplug appears at kernel boot time.
May be some chipset not recognized on my motherboard