Package: installation-reports
Debian-installer-version: <debian-31r0a-i386-netinst.iso from web> 24 August 2005
uname -a: <Linux>
Date: < >
Method: < Minimal CD What did you boot off Minimal? If network install, from where? ftp.au.debian. org stable>
Machine: Rebuilt Intel D915GAGLK
Processor:
Memory: 512Mb
Root Device: <IDE /dev/sda1
Root Size/partition table: <Default With Swap partition only >
Output of lspci
0000:00:00.0 Host bridge: Intel Corp. 915G/P/GV Processor to I/O
Controller (rev 04)
0000:00:01.0 PCI bridge: Intel Corp. 915G/P/GV PCI Express Root Port (rev 04)
0000:00:02.0 VGA compatible controller: Intel Corp.
82915G Express Chipset Family Graphics Controller (rev 04)
0000:00:1b.0 0403: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) High
Definition Audio Controller (rev 03)
0000:00:1c.0 PCI bridge: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) PCI
Express Port 1 (rev 03)
0000:00:1c.1 PCI bridge: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) PCI
Express Port 2 (rev 03)
0000:00:1c.2 PCI bridge: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) PCI
Express Port 3 (rev 03)
0000:00:1c.3 PCI bridge: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) PCI
Express Port 4 (rev 03)
0000:00:1d.0 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family)
USB UHCI #1 (rev 03)
0000:00:1d.1 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family)
USB UHCI #2 (rev 03)
0000:00:1d.2 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family)
USB UHCI #3 (rev 03)
0000:00:1d.3 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family)
USB UHCI #4 (rev 03)
0000:00:1d.7 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family)
USB2 EHCI Controller (rev 03)
0000:00:1e.0 PCI bridge: Intel Corp. 82801 PCI Bridge (rev d3)
0000:00:1f.0 ISA bridge: Intel Corp. 82801FB/FR (ICH6/ICH6R) LPC
Interface Bridge
(rev 03)
0000:00:1f.1 IDE interface: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) IDE
Controller (rev 03)
0000:00:1f.2 IDE interface: Intel Corp. 82801FB/FW (ICH6/ICH6W) SATA Controller
(rev 03)
0000:00:1f.3 SMBus: Intel Corp. 82801FB/FBM/FR/FW/FRW
(ICH6 Family) SMBus Controller (rev 03)
0000:04:00.0 Ethernet controller: Marvell Technology Group Ltd.: Unknown device
4361 (rev 17)
0000:06:00.0 Ethernet controller: Realtek
Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
0000:06:01.0 Multimedia audio controller: Ensoniq
ES1371 [AudioPCI-97] (rev 08)
and lspci -n:
0000:00:00.0 0600: 8086:2580 (rev 04)
0000:00:01.0 0604: 8086:2581 (rev 04)
0000:00:02.0 0300: 8086:2582 (rev 04)
0000:00:1b.0 0403: 8086:2668 (rev 03)
0000:00:1c.0 0604: 8086:2660 (rev 03)
0000:00:1c.1 0604: 8086:2662 (rev 03)
0000:00:1c.2 0604: 8086:2664 (rev 03)
0000:00:1c.3 0604: 8086:2666 (rev 03)
0000:00:1d.0 0c03: 8086:2658 (rev 03)
0000:00:1d.1 0c03: 8086:2659 (rev 03)
0000:00:1d.2 0c03: 8086:265a (rev 03)
0000:00:1d.3 0c03: 8086:265b (rev 03)
0000:00:1d.7 0c03: 8086:265c (rev 03)
0000:00:1e.0 0604: 8086:244e (rev d3)
0000:00:1f.0 0601: 8086:2640 (rev 03)
0000:00:1f.1 0101: 8086:266f (rev 03)
0000:00:1f.2 0101: 8086:2651 (rev 03)
0000:00:1f.3 0c05: 8086:266a (rev 03)
0000:04:00.0 0200: 11ab:4361 (rev 17)
0000:06:00.0 0200: 10ec:8139 (rev 10)
0000:06:01.0 0401: 1274:1371 (rev 08)
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [Y]
Configure network HW: [N] Did not work until an extra network card installed
Config network: [y]
Detect CD: [y]
Load installer modules: [y]
Detect hard drives: [y]
Partition hard drives: [y]
Create file systems: [y]
Mount partitions: [y]
Install base system: [y]
Install boot loader: [y]
Reboot: [y]
Comments/Problems:
- The old
mother board of the machine had been replaced with an Intel D915GAGLK
- The install
would only work with Kernal 26
- The network on
board was not detected
- A network
card was installed and was detected
- No partitioning
was used except the default (this was a mistake on my part)
- I make a mistake
with the install as I did not realise taskselect
needed the spacebar to select the workgroup – This lead to a lot of
pain!!
- The audio is
still not working even after I installed a spare sound card
Recommendations
- a press space
bar to select be placed in the taskselect menu
THIS SHOULD BE DONE
- It would be
nice if autodetect and drivers for the Intel D915GAGLK
were available
I was very please with the install it was relatively easy – This install
was much easier than a previous Woody install in which I needed much help
I hope that this report is of use to you -
Laurie
Aldridge
24 Balmer Cres
Woonona 2517 NSW
Australia
E-mail land@bigpond.net.au
Phone (02)4284 0132
Mobile Phone 0403 718 522