Bug#323151: Package: intallation-reports
Package: installation-reports
Debian-installer-version: 13 Aug 2005 http://people.debian.org/~joeyh/d-i/images/daily/floppy/
uname -a: Linux (none) 2.4.27-2-386 #1 Mon May 16 16:47:51 JST 2005 i686 unknown
Date: 14 Aug 2005
Method: floppy: boot, root, net-drivers.img
Machine: IBM Thinkpad T22 2647-8EU
Processor: P-III 900 MHz
Memory: 512 MB sdram so-dimm
Root Device: 12GB Fujitsu hard drive
Root Size/partition table: didn't get that far
Output of lspci and lspci -n: command not available
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [O]
Configure network HW: [E]
Config network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Create file systems: [ ]
Mount partitions: [ ]
Install base system: [ ]
Install boot loader: [ ]
Reboot: [ ]
Comments/Problems:
Note: 1) only tried one set of floppies. (I can make another set if warranted.)
2) After trying the 13 Aug 2005 floppies, I successfully loaded the machine
using the stock sarge floppy images. There were hiccups, but the
WAY forward was never completely blocked as it was with the
13 aug 2005 images.
13 Aug 2005 images:
Put in boot, root, picked: eng; us; said no to drivers; am-eng
keyboard
built-in e100 NIC was not detected (didn't work with stable sarge images either).
(I did not grok "boot install24")
Then it "finds" a FireWire interface. said no to that
the net-drivers image errors on "Loading ipv6-modules-2.4.27-2-386-di failed for
unknown reasons"
going back causes a bad screen flicker (black screen with white cursor-block in
lower left). That is the end of the experiment.
Reply to: