INSTALL REPORT (beta 2, stock standard)
Package: installation-reports
INSTALL REPORT
Debian-installer-version: Beta 2
uname -a: Linux brutus 2.4.24-1-686 #1 Tue Jan 6 21:29:44 EST 2004 i686 GNU/Linux
Date: Sat Jan 24 17:25:08 EST 2004
Method: businesscard CD, net install, transparently proxied
Machine: Noname clone
Processor: PIV
Memory: 256M
Root Device: IDE, /dev/hda2
Root Size/partition table:
Disk /dev/hda: 120.0 GB, 120034123776 bytes
255 heads, 63 sectors/track, 14593 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/hda1 * 1 7295 58597056 7 HPFS/NTFS
/dev/hda2 7296 7356 489982+ 83 Linux
/dev/hda3 7357 7372 128520 82 Linux swap
/dev/hda4 7373 14593 58002682+ 8e Linux LVM
Filesystem Size Used Avail Use% Mounted on
/dev/hda2 464M 182M 259M 42% /
[ note I left /dev/hda4 alone from a previous installation test ]
Output of lspci:
00:00.0 Host bridge: Intel Corp. 82845 845 (Brookdale) Chipset Host Bridge (rev 03)
00:01.0 PCI bridge: Intel Corp. 82845 845 (Brookdale) Chipset AGP Bridge (rev 03)
00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB/EB PCI Bridge (rev 12)
00:1f.0 ISA bridge: Intel Corp. 82801BA ISA Bridge (LPC) (rev 12)
00:1f.1 IDE interface: Intel Corp. 82801BA IDE U100 (rev 12)
00:1f.2 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #1) (rev 12)
00:1f.3 SMBus: Intel Corp. 82801BA/BAM SMBus (rev 12)
00:1f.4 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #2) (rev 12)
01:00.0 VGA compatible controller: nVidia Corporation NV11 [GeForce2 MX/MX 400] (rev b2)
03:00.0 Multimedia audio controller: Ensoniq ES1370 [AudioPCI] (rev 01)
03:01.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100] (rev 08)
03:02.0 FireWire (IEEE 1394): Texas Instruments TSB12LV23 IEEE-1394 Controller
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
base-config seemed to get stuck in a loop configuring my APT sources.
I think it would be good if d-i could somehow seed base-config, so it doesn't
ask some of the same questions over again, i.e. APT source. Use the same one
supplied during the base system installation, or at least default to it.
Reply to: