Bug#286814: Package: Sarge Installer
Package: Sarge Installer
Hi,
I think I may have found a problem with the latest debian installer.
I have installed debian onto a 2 machines that already had a formatted =
ext2 partition. I used this ext2 partition for / and told the installer =
to use ext3.=20
When debian boots, /etc/fstab thinks the partition is ext3, but there is =
no journal. I created a journal with tune2fs -j /dev/hda2 OK after the =
install.
from dmesg:
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-disk driver.
hda: 80043264 sectors (40982 MB) w/2048KiB Cache, CHS=3D79408/16/63, =
UDMA(100)
Partition check:
/dev/ide/host0/bus0/target0/lun0: [PTBL] [4982/255/63] p1 p2 p3 < p5 >
Journalled Block Device driver loaded
ext3: No journal on filesystem on ide0(3,2)
ext3: No journal on filesystem on ide0(3,2)
thanks
Mike Haber
DISCLAIMER:
This email is intended solely for the addressee. It may contain private and confidential information. If you are not the intended addressee, please take no action based on it nor show a copy to anyone. In this case, please reply to this email to highlight the error. Opinions and information in this email that do not relate to the official business of Nottingham Trent University shall be understood as neither given nor endorsed by the University.
Nottingham Trent University has taken steps to ensure that this email and any attachments are virus-free, but we do advise that the recipient should check that the email and its attachments are actually virus free. This is in keeping with good computing practice.
Reply to: