Dell OptiPlex GX280 hangs after installation

["Jeffrey A. Edlund" <jae-debian@glaxonlabs.com>]

Using pre-rc2 I was able to install sarge on a dell optiplex GX280.  I
had to use the linux26 boot option to get support for the intel ICH6
SATA controller.  The installation went smoothly through the
installation of GRUB, but after rebooting the computer to finish the
configuration the kernel just hangs after the line "Real Time Clock
Driver v1.12".

I've tried using various combinations of expert26 mode,LILO, ext3
instead of reiserfs, etc. All with the same result.  

Any ideas?

Thanks, 

Jeffrey