Bug#269630: Installation Report amd64(gcc-3.2)
Package: installation-reports
Debian-installer-version: SVN revision 20628
uname -a: 2.6.8-3-amd64
Date: 20040902
Method: grabbed SVN image, built monolithic for
amd64(gcc-3.4), wrote it on a USB stick,
boot using 'expert vga=0x318'
packages grabbed from http://debian-amd64.alioth.debian.org/gcc-3.4/
Machine: Shuttle SN85G4V2
Processor: AMD64, 3200+, Newcastle
Memory: 1 GB
Root Device: SATA (sil_sata)
Root Size/partition table:
Disk /dev/sda: 160.0 GB, 160041885696 bytes
255 heads, 63 sectors/track, 19457 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sda1 * 1 487 3911796 83 Linux
/dev/sda2 488 1461 7823655 83 Linux
/dev/sda3 1462 1705 1959930 82 Linux swap
/dev/sda4 1706 19457 142592940 5 Extended
/dev/sda5 1706 9001 58605088+ 83 Linux
/dev/sda6 9002 19457 83987788+ 83 Linux
Output of lspci and lspci -n: NA
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [ ]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [E]
Create file systems: [E]
Mount partitions: [ ]
Install base system: [ ]
Install boot loader: [ ]
Reboot: [ ]
Comments/Problems:
Using "Manually edit partition table" in partman I
was _not_ asked for the mount point for /dev/sda1.
This option was missing (or I was too blind to see
it).
On the next installation step there was an error message
saying I did not specify the root device.
Regards
Harri
Reply to: