Bug#255042:
>> Installing the base system failed at between 80 and 90 % under both
>> 2.4 and 2.6. It was impossible to continue past the error.
>
>When this happens, can you change to VT3 and VT4 (alt-f3, alt-f4) and
>see what the error message says?
I went back to the beta4 installer disk and the system is up and running
now. When I had the problem I looked at the other virtual consoles, but
none of the output seemed to show what had happened to the install
process. If I have a chance I'll try installing to the swap partition
Monday. What in particular should I look for?
Is there any helpful information I could give you from the installed system?
The new installer is great, BTW. Thanks for all the work you guys have
put into it.
-Steve
Reply to: