Re: New netinst iso
the owner <editor@postscript.port5.com> writes:
> Goswin-
>
> I apologize for the mixup:
>
>> Oops: That was actually an error reading the Release file not Packages file as previously here:
>
> The 18 Feb sarge-amd64-netinst.iso Installer error message said:
> "error reading /cdrom/dists//Release "
>
>
> I am fairly sure that would be the same as this showing the same type
> of failure:
>
>
> root@workstation:~> cat /mnt/iso9660/dists/sarge/Release
> attempt to access beyond end of device
> loop0: rw=0, want=260716, limit=224649
> Buffer I/O error on device loop0, logical block 65178
That was more important. It indicates your iso is to small.
> I took the 18 Feb image downloaded from alioth and mounted that to
> loop iso9660 and found the above. That must be
> the same error as during the CDROM run of the Installer.
>
> Here is the 18 Feb image that caused the problem:
>
> 2cb2cc2fe9544547dac49d0b8a26dd31 sarge-amd64-netinst.iso
goswin-guest@haydn:~/archive/install-images$ cat sarge-amd64-netinst.iso.md5sum
530f958e147737a3c9fc372a36a3c233 sarge-amd64-netinst.iso
And this prooves it is corrupt.
Sorry, this is my fault I think. The file on Alioth is 18MB short of
what it should be. Must have missed rsync dying on the upload. I
should add an md5sum check after the upload to my script.
sarge-amd64-netinst.iso
118516672 88% 15.46kB/s 0:16:46
Try again in a few minutes.
MfG
Goswin
Reply to: