I aplogize if this was already sent to the list. I had some confusion when subscribing and I had sent this before I got my subscription confirmation back.
Anyway, below is the original message...
I have a PWS 500a. Im using AlphaBIOS and have correctly set up OS Type. When the floppy boots, it loads loadlin.exe fine, the starts MILO. When I type "show" or "ls" or "boot blah" at the MILO prompt, it loads the RAMDISK, finds my cdrom, floppy, and qlogicisp controller, but hangs after the following two lines:
scsi0: QLogic ISP1020 SCSI on PCI bus 1 device 4 irq 27 base 0x9000
scsi : 1 host.
It just sits here endlessly. I've tried different versions of Miata, but to no avail. I tried a different hard drive and scsi cable, also did not help.
I am not familiar with MILO so I do not know what comes after the above message. Any suggestions would be greatly appreciated.