Re: SATA HD hotplug "Authentication is required"
On Sun, 6 Dec 2015 13:07:37 +0000
Brian <ad44@cityscape.co.uk> wrote:
> On Sun 06 Dec 2015 at 07:53:41 -0300, Renaud OLGIATI wrote:
>
> > On Sat, 5 Dec 2015 23:31:49 +0000
> > Brian <ad44@cityscape.co.uk> wrote:
> >
> > > > > I think udisks treats drives attached via eSATA as "system" devices for
> > > > > which the default policykit rules only allow mounting with
> > > > > authentication. These should show up as "HintSystem: true" in the
> > > > > output of "udisksctl dump".
> >
> > > > root@ron:/home/ron # udisksctl dump
> > > > bash: udisksctl: command not found
> > > > ???
> >
> > > dpkg -l udisks2
> >
> > root@ron:/home/ron # apt-get install udisks2
> > Reading package lists... Done
> > Building dependency tree
> > Reading state information... Done
> > Package udisks2 is not available, but is referred to by another package.
> > This may mean that the package is missing, has been obsoleted, or
> > is only available from another source
> >
> > E: Package 'udisks2' has no installation candidate
>
> On an updated Jessie:
<snip>
I am still on Wheezy (an in no hurry to upgrade)...
Cheers,
Ron.
--
My karma just ran over your dogma.
-- http://www.olgiati-in-paraguay.org --
Reply to: