Re: 3ware raid smartctl
Hallo Christophh,
tschuldigung, dass ich an dich direkt schrieb. Bedienungsfehler ;-)
# smartctl -d 3ware,1 /dev/sda
das habe ich u.a. in der Manpage von smartctl gefunden:
"[...] 3ware,N - [FreeBSD and Linux only] the device consists of one or
more ATA disks connected to a 3ware RAID controller. The non-negative
integer N (in the range from 0 to 127 inclusive) denotes which disk on
the controller is monitored. Use syntax such as:
smartctl -a -d 3ware,2 /dev/sda
smartctl -a -d 3ware,0 /dev/twe0
smartctl -a -d 3ware,1 /dev/twa0
smartctl -a -d 3ware,1 /dev/twl0
The first two forms, which refer to devices /dev/sda-z and
/dev/twe0-15, may be used with 3ware series 6000, 7000, and 8000 series
controllers that use the 3x-xxxx driver. Note that the /dev/sda-z form
is deprecated starting with the Linux 2.6 kernel series and may not be
supported by the Linux kernel in the near future. The final form, which
refers to devices /dev/twa0-15, must be used with 3ware 9000 series
controllers, which use the 3w-9xxx driver.
The devices /dev/twl0-15 must be used with the 3ware/LSI 9750 series
controllers which use the 3w-sas driver.
Note that if the special character device nodes /dev/twl?, /dev/twa?
and /dev/twe? do not exist, or exist with the incorrect major or minor
numbers, smartctl will recreate them on the fly. Typically /dev/twa0
refers to the first 9000-series controller, /dev/twa1 refers to the
second 9000 series controller, and so on. [...]"
Gruß
Stefan
Reply to: