Re: sarge netinst on scsi

[Alvin Smith <email@alvinsmith.com>]

Ok, I switched to expert-mode.  It seems that the module it loaded when the 
CDROM that holds the install media is detected, which is on a SCSI device, 
but the partitioner still does not show the SCSI hard drive.

What am I missing?

Thanks.

On Wednesday 03 November 2004 01:25 pm, Macskasi Csaba wrote:
> You can switch to expert-mode and load the module for your scsi-card/chip.
>
> Best Regards,
> Macskasi Csaba
>
> On Wednesday 03 November 2004 19.06, Alvin Smith wrote:
> > I am trying to install sarge on a Dell Precision 410 that has a SCSI
> > drive and two IDE drives.  The partitioner only shows the IDE drives.  I
> > used the boot option "linux26 aic7xxx=no_probe".
> >
> > Is there something that I can do to make the installer see all available
> > partitions?
> >
> > Thanks
> > --
> > Alvin Smith

-- 
Alvin Smith