Re: Matrox and Opengl howto????
did you install the dri modules for the matrox in the kernel?
> hi...
> I just install the mplayer and zsnes
> I plus the opengl with both software...
>
> However, when I try to use them with the OpenGL.
> It got too slow.
>
> almos 1fp!!!
>
> I use the G450 and the driver from the www.matrox.com
>
> My XF86Config-4 had
>
>
> Section "Module"
> Load "ddc"
> Load "GLcore"
> Load "dbe"
> Load "extmod"
> Load "glx"
> Load "dri"
> Load "pex5"
> Load "record"
> Load "xie"
> Load "bitmap"
> Load "xtt"
> Load "speedo"
> Load "type1"
> Load "vbe"
> #Load "int10"
> EndSection
>
> Section "Device"
> Identifier "MATROX CARD 1"
> Driver "mga"
> VideoRam 32768
> Option "AGPMode" "2"
> Option "hw cursor" "on"
> BusID "PCI:1:0:0"
> EndSection
>
>
> Section "DRI"
> Mode 0666
> EndSection
>
> Anything wrong with my setup steps??
>
> I also used the xlibmesa. The apt remove the mesag3..Is it needed???
>
> Thanks for answering
>
>
>
>
> --
> To UNSUBSCRIBE, email to debian-testing-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: