Re: mkfs.ext2 - state D partitioning stops at 33% /boot
> Rethinking that, I assume if an UltraSPARC machine boots from a CDROM
> drive attached to the built-in ATA controller and the installer later
> can find the disc to start the installation, it should also work with
> HDDs on that controller, though maybe not with UDMA speeds, but that was
> a common issue with some older chipsets IIRC. Not sure if these issues
> were with disc drives exclusively or also with disk drives.
My Ultra 10 has a CMD646 though, which supposedly supports up to UDMA2.
Dumb question: Did you check the cabling/jumper settings?
Reply to: