Да, с температурой плохо, но 46 - это нормально.85 - обычное значение для Trip Temperature, это предел, диск выключится, если будет столько.
> Тоже хорошо лист раздулся ^^^^^^^^^^^ Только на этом диске. > С соседнего диска покажи вывод, для сравнения. Там всё ok. Приложил для sdb. 29.10.2020 13:06, Andrey Jr. Melnikov пишет:
artiom <artiom14@yandex.ru> wrote:[-- text/plain, encoding 8bit, charset: utf-8, 41 lines --]Здравствуйте.Диск вываливается из пула второй раз. Это говорит о том, что диск пора менять?Угу.Полный отчёт приложил.[...]=== START OF READ SMART DATA SECTION === SMART Health Status: OKCurrent Drive Temperature: 46 CЖарко им там. Сильно жарко.Drive Trip Temperature: 85 CManufactured in week 06 of year 2016 Specified cycle count over device lifetime: 50000 Accumulated start-stop cycles: 113 Specified load-unload count over device lifetime: 600000 Accumulated load-unload cycles: 1029 Elements in grown defect list: 2063Тоже хорошо лист раздулся ^^^^^^^^^^^Vendor (Seagate) cache information Blocks sent to initiator = 16398532122509312Error counter log: Errors Corrected by Total Correction Gigabytes Total ECC rereads/ errors algorithm processed uncorrected fast | delayed rewrites corrected invocations [10^9 bytes] errors read: 275976895 188907 0 276165802 12936691 40078.468 21 write: 0 237 0 237 1360289 44744.849 0 verify: 0 0 0 0 41935114 0.000 0Non-medium error count: 7С соседнего диска покажи вывод, для сравнения.
smartctl 6.6 2017-11-05 r4594 [x86_64-linux-5.7.0-0.bpo.2-amd64] (local build) Copyright (C) 2002-17, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Vendor: HGST Product: HUS724040ALS640 Revision: A320 Compliance: SPC-4 User Capacity: 4,000,787,030,016 bytes [4.00 TB] Logical block size: 512 bytes LU is fully provisioned Rotation Rate: 7200 rpm Form Factor: 3.5 inches Logical Unit id: 0x5000cca07369c40c Serial number: PEHW55YX Device type: disk Transport protocol: SAS (SPL-3) Local Time is: Thu Oct 29 23:22:33 2020 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled Temperature Warning: Enabled Read Cache is: Enabled Writeback Cache is: Enabled === START OF READ SMART DATA SECTION === SMART Health Status: OK Current Drive Temperature: 45 C Drive Trip Temperature: 85 C Manufactured in week 06 of year 2016 Specified cycle count over device lifetime: 50000 Accumulated start-stop cycles: 113 Specified load-unload count over device lifetime: 600000 Accumulated load-unload cycles: 1030 Elements in grown defect list: 0 Vendor (Seagate) cache information Blocks sent to initiator = 30411439726395392 Error counter log: Errors Corrected by Total Correction Gigabytes Total ECC rereads/ errors algorithm processed uncorrected fast | delayed rewrites corrected invocations [10^9 bytes] errors read: 375435 1 0 375436 1195859 52736.418 0 write: 0 0 0 0 1909068 56323.792 0 verify: 0 0 0 0 10458 0.000 0 Non-medium error count: 0 SMART Self-test log Num Test Status segment LifeTime LBA_first_err [SK ASC ASQ] Description number (hours) # 1 Background short Completed - 1813 - [- - -] # 2 Background long Completed - 230 - [- - -] # 3 Background short Completed - 221 - [- - -] # 4 Background short Completed - 201 - [- - -] # 5 Background short Completed - 157 - [- - -] # 6 Background short Completed - 133 - [- - -] # 7 Background short Completed - 2 - [- - -] # 8 Background short Completed - 2 - [- - -] # 9 Background short Completed - 1 - [- - -] Long (extended) Self Test duration: 37452 seconds [624.2 minutes] Background scan results log Status: waiting until BMS interval timer expires Accumulated power on time, hours:minutes 22113:38 [1326818 minutes] Number of background scans performed: 145, scan progress: 0.00% Number of background medium scans performed: 145 Protocol Specific port log page for SAS SSP relative target port id = 1 generation code = 2 number of phys = 1 phy identifier = 0 attached device type: no device attached attached reason: unknown reason: power on negotiated logical link rate: phy enabled; unknown attached initiator port: ssp=0 stp=0 smp=0 attached target port: ssp=0 stp=0 smp=0 SAS address = 0x5000cca07369c40d attached SAS address = 0x0 attached phy identifier = 0 Invalid DWORD count = 0 Running disparity error count = 0 Loss of DWORD synchronization = 0 Phy reset problem = 0 Phy event descriptors: Invalid word count: 0 Running disparity error count: 0 Loss of dword synchronization count: 0 Phy reset problem count: 0 relative target port id = 2 generation code = 2 number of phys = 1 phy identifier = 1 attached device type: SAS or SATA device attached reason: unknown reason: unknown negotiated logical link rate: phy enabled; 6 Gbps attached initiator port: ssp=1 stp=1 smp=1 attached target port: ssp=0 stp=0 smp=0 SAS address = 0x5000cca07369c40e attached SAS address = 0x5d05099000005171 attached phy identifier = 4 Invalid DWORD count = 0 Running disparity error count = 0 Loss of DWORD synchronization = 0 Phy reset problem = 0 Phy event descriptors: Invalid word count: 0 Running disparity error count: 0 Loss of dword synchronization count: 0 Phy reset problem count: 0