Re: Partition check
On Tue, May 31, 2005 at 09:12:47PM -0300, Gunther Furtado wrote:
> Hello,
>
> This is the reading I get whe I boot the 2.4.25-behn kernel.
>
> Parition check:
> hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12
>
> And this is when i boot a kernel I compiled from linux-2.4.26 sources.
>
> Partition check:
> /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12
>
> Can anyone tell what did I switched off from Behn's kernel configuration?
The benh kernel accesses the hard disk as an IDE device. Your later kernel
sees it as a SCSI device. First check if you have a boot parameter like
"hda=scsi" and if so, remove it.
If that isn't it, check the SCSI and IDE settings in your config. Sorry, I
don't know exactly which ones.
--
Martin
---------------------------------------------------------------------------
30 years from now GNU/Linux will be as redundant a term as UNIX/MERT is
today. - Martin Habets
---------------------------------------------------------------------------
Reply to: