Re: [debian-knoppix] knoppix 3.4 kernel 2.6.6 [LONG]
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Alle 00:17, mercoledì 26 maggio 2004, Klaus Knopper ha scritto:
> Uhm... The 2.6.6 kernel on Knoppix is equipped WITH serial ata support,
> to the best of my knowledge. Are you asking how to turn it off?
Not for sure! :-)
> > If Klaus Knopper is hearing, please include modules from /scsi ->
> > low-level-drivers > serial ata in the next release
> Am I missing something? I thought this is the default.
I really don't know then how to use my hardware on this particular version of
knoppix I've downloaded from a bittorrent link found on www.knoppix.org.
I just put in the cd-rom md5sum checked and go with "knoppix26 lang=it" at
boot prompt, then I ran a few test, then saved on /dev/sda, my usb-stick,
which would be seen as /dev/sdc, 'cause of two sata drives if sata is
properly* recognized.
First from my working previously installed debian dmesg about my sata config:
libata version 1.02 loaded.
ata1: SATA max UDMA/133 cmd 0xD800 ctl 0xD402 bmdma 0xC800 irq 5
ata2: SATA max UDMA/133 cmd 0xD000 ctl 0xCC02 bmdma 0xC808 irq 5
ata1: dev 0 cfg 49:2f00 82:7c6b 83:7f09 84:4003 85:7c69 86:3e01 87:4003
88:407f
ata1: dev 0 ATA, max UDMA/133, 320173056 sectors (lba48)
ata1: dev 0 configured for UDMA/133
scsi0 : sata_sis
ata2: dev 0 cfg 49:2f00 82:346b 83:7f01 84:4003 85:3c68 86:3c01 87:4003
88:00ff
ata2: dev 0 ATA, max UDMA7, 312581808 sectors (lba48)
ata2: dev 0 configured for UDMA/133
scsi1 : sata_sis
Vendor: ATA Model: Maxtor 6Y160M0 Rev: 1.02
Type: Direct-Access ANSI SCSI revision: 05
Vendor: ATA Model: SAMSUNG SP1614C Rev: 1.02
Type: Direct-Access ANSI SCSI revision: 05
SCSI device sda: 320173056 512-byte hdwr sectors (163929 MB)
SCSI device sda: drive cache: write through
sda: sda1 sda2 < sda5 sda6 sda7 sda8 sda9 >
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sdb: 312581808 512-byte hdwr sectors (160042 MB)
SCSI device sdb: drive cache: write through
sdb: sdb1 sdb2 < sdb5 sdb6 sdb7 sdb8 sdb9 >
Attached scsi disk sdb at scsi1, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0
Attached scsi generic sg1 at scsi1, channel 0, id 0, lun 0, type 0
tremendo:/etc/apt# scsiinfo -i /dev/sda | tail - 4
Vendor: ATA
Product: Maxtor 6Y160M0
Revision level: 1.02
then the test on running knoppix3.4 (17-05-2004) after kde bootup (no other
problems but disk, fine work !):
marco@tremendo:/~$ cat /mnt/usb-mem/test # created on 2004-05-26 01:04
root@ttyp0[knoppix]# modprobe sata-sis
FATAL: Module sata_sis not found.
root@ttyp0[knoppix]# lsmod
Module Size Used by
snd_mixer_oss 19072 0
snd 49540 1 snd_mixer_oss
via_agp 9856 0
sworks_agp 11424 0
sis_agp 9472 1
nvidia_agp 10012 0
intel_mch_agp 12044 0
intel_agp 18968 0
efficeon_agp 10496 0
ati_agp 10636 0
amd_k7_agp 10124 0
amd64_agp 12872 0
ali_agp 9600 0
agpgart 31564 11
via_agp,sworks_agp,sis_agp,nvidia_agp,intel_mch_agp,intel_agp,efficeon_agp,ati_agp,amd_k7_agp,amd64_agp,ali_agp
autofs 19456 1
af_packet 21124 0
emu10k1 86276 1
sound 80232 1 emu10k1
soundcore 12000 4 snd,emu10k1,sound
ac97_codec 19840 1 emu10k1
sis900 21124 0
crc32 8448 1 sis900
emu10k1_gp 7040 0
gameport 8192 1 emu10k1_gp
parport_pc 38176 0
parport 38848 1 parport_pc
8250 34448 0
serial_core 22912 1 8250
ds 17920 0
yenta_socket 20736 0
pcmcia_core 58240 2 ds,yenta_socket
thermal 14992 0
processor 20672 1 thermal
fan 7564 0
button 9496 0
battery 12428 0
ac 8076 0
rtc 15432 0
cloop 15456 1
ohci1394 33792 0
ieee1394 305296 1 ohci1394
usb_storage 66816 0
ohci_hcd 20864 0
uhci_hcd 31112 0
usbcore 94420 5 usb_storage,ohci_hcd,uhci_hcd
ide_cd 40576 0
ide_scsi 17540 2
root@ttyp0[knoppix]# uname -a
Linux Knoppix 2.6.6 #2 SMP Fri May 14 20:38:30 CEST 2004 i686 GNU/Linux
root@ttyp0[knoppix]# lspci
0000:00:00.0 Host bridge: Silicon Integrated Systems [SiS] 746 Host (rev 10)
0000:00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SG86C202
0000:00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS964 [MuTIOL Media
IO] (rev 36)
0000:00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev
01)
0000:00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.0
Controller (rev 0f)
0000:00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.0
Controller (rev 0f)
0000:00:03.2 USB Controller: Silicon Integrated Systems [SiS] USB 1.0
Controller (rev 0f)
0000:00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0
Controller
0000:00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] SiS900 PCI
Fast Ethernet (rev 90)
0000:00:05.0 RAID bus controller: Silicon Integrated Systems [SiS]: Unknown
device 0180 (rev 01)
0000:00:0b.0 Multimedia audio controller: Creative Labs SB Audigy (rev 03)
0000:00:0b.1 Input device controller: Creative Labs SB Audigy MIDI/Game port
(rev 03)
0000:01:00.0 VGA compatible controller: nVidia Corporation: Unknown device
0326 (rev a1)
root@ttyp0[knoppix]# cat /etc/fstab
/proc /proc proc defaults 0 0
/sys /sys sysfs noauto 0 0
/dev/pts /dev/pts devpts mode=0622 0 0
/dev/fd0 /mnt/auto/floppy auto user,noauto,exec,umask=000 0 0
/dev/cdrom /mnt/auto/cdrom auto user,noauto,exec,ro 0 0
# Added by KNOPPIX
noauto,users,exec 0 0
root@ttyp0[knoppix]# scsi_info /dev/sda
SCSI_ID="0,0,0"
HOST="2"
MODEL="SanDisk Cruzer Mini"
FW_REV="0.1"
root@ttyp0[knoppix]# cat /boot/config-2.6.6 | grep -i sata
# CONFIG_SCSI_SATA is not set
root@ttyp0[knoppix]# ll /boot/config-2.6.6
- -rw-r--r-- 1 root root 53510 2004-05-14 20:37 /boot/config-2.6.6
root@ttyp0[knoppix]# cat /cdrom/KNOPPIX/knoppix-version
3.4 2004-05-17
root@ttyp0[knoppix]# cat /cdrom/KNOPPIX/md5sums | grep version
d5efb64db80e40c1cc8e88781ee070c0 *KNOPPIX/knoppix-version
root@ttyp0[knoppix]# find /lib/modules/ -iname "*sata*" -print
root@ttyp0[knoppix]#
Maybe I missed something really important, but I cannot see serial-ata support
in this knoppix version, or just no support that I can handle. Any hints?
(I'm trying in fact to remaster this one with serial-ata support, but I miss
something on mkinitrd creation, lots of .o in lkm of minirt26.gz
from /cdrom/boot/isolinux when I was used to see .ko for kernels 2.6... Can I
look at your scripts for making the knoppix kernels and initrds?, please?)
*properly: In my bios I cannot chose "emulation", "Sata-first" or similar, but
just "enabled" or "disabled" for serial ata setting. With the same disks on
my previous motherboards (both with sata-via chipets, differently from the
current mb) they (emulation) apperead under /dev/hde and /dev/hdg,
respectively.
- --
Marco Amadori <elessar@dei.unipd.it>
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)
iD8DBQFAs/z2Q8Nx9BqyEXoRAutsAJsGwJ7L/UxftqDivxS4dYwlAFSvTwCgvhUA
gM4e1vtmZ8E9N6JeC3lX0VI=
=PxD8
-----END PGP SIGNATURE-----
_______________________________________________
debian-knoppix mailing list
debian-knoppix@linuxtag.org
http://mailman.linuxtag.org/mailman/listinfo/debian-knoppix
Reply to: